dragspecialties.com All part numbers in BLUE are new for 2026. SECTION 11 WINDSHIELDS & FAIRINGS AUDIO, COMMUNICATION & MOUNTS SADDLEBAGS & LUGGAGE SEATS & SISSY BARS FUEL/AIR SYSTEMS EXHAUST TRANSMISSION & DRIVELINE ENGINE GASKETS & SEALS LIGHTING ELECTRICAL HANDLEBARS, CONTROLS & MIRRORS CABLES TANKS & OIL FILTERS BRAKES DASHES & GAUGES FENDERS & LICENSE PLATE FRAMES HARDWARE, COVERS & GENERAL FRAMES & SUSPENSION FOOTRESTS & FLOORBOARDS WHEELS & AXLES 1278 See OLDBOOK For Early Model Applications PART # DESCRIPTION 0904-0002 Automatic turn signal canceling module, custom fitment 2050-0215 For 94-96 XL w/ installed 8-position FEMALE connector PART # DESCRIPTION 7808-1030 For 99-00 FLHT/FLHR, 00 FXST/FLST, 99-00 Dyna and 97-03 XL w/ installed 8-pin MALE connector PLUG-IN AUTOMATIC TURN SIGNAL CANCELERS •Plug in and replace the OEM signal canceler •Does not require stock speedometer for proper operation •Automatically flashes for 11 seconds; can be manually canceled at any time •Built-in emergency flasher mode •Built-in load equalizer runs LEDs of up to 100W per side PART # DESCRIPTION 2050-0318 For 18-24 FXBR/FXBRS 2050-0316 For 11-17 FXS/B, 12-17 FLS/S 2050-0315 For 12-17 FXD/FXDWG w/ OEM red rear run/brake/turn signals 2050-0317 For 14-22 XL (except RH Sportster) w/ OEM red rear run/brake/turn signals BRAKE LIGHT ELIMINATORS •Separates running and brake light functionality from flashing turn signal function •Allows the use of amber turn signals functioning separately from brake light •Enables use of brake and running lights, left- and right-only turn signals and license plate illumination •Includes new rear fender harness to replace stock PART # DESCRIPTION 2050-0188 For 14-23 FLHX/FLHTCU/FLTRX (except 23 FLHXSE/FLTRXSE) BRAKE LIGHT ELIMINATOR •Removes the brake light feature from the rear turn signals •Keeps the turn signals and brake light functions separate •Module comes with a new rear fender harness to allow customers flexibility when wiring in new signals and taillights •Direct plug-in installation •Made in the U.S.A. NOTE: Requires the separate purchase of single-function amber lights to be used as turn signals. PART # DESCRIPTION 2120-0084 Center brake light module CENTER BRAKE LIGHT MODULE •Allows installation of a center brake light on choppers and custom bikes when used with Thunder Heart’s Micro Harness Controller PART #2120-0023 •Compatible with LED and incandescent bulbs •Solid-state construction, fully circuit-protected and has no relays to wear out •Compact size of 2” L x 0.6” W x 0.5” H lets you mount it just about anywhere •12V, 3A max current capacity •Simple four-wire hookup; wiring diagram included •Made in the U.S.A. PART # DESCRIPTION STATIC MODULES 2050-0303 For 99-13 FLHT/FLHR, 99-09 FLTR, 06-09 FLHX, 00-10 FXST/FLST, 99-11 Dyna, 86-13 XL and 01-17 V-Rod 2050-0304 For 99-13 FLHT/FLHR, 99-09 FLTR, 06-09 FLHX, 00-10 FXST/FLST and 99-03 XL PART # DESCRIPTION DYNAMIC MODULES 2050-0308 For 99-13 FLHT/FLHR, 99-09 FLTR, 06-09 FLHX, 00-10 FXST/FLST, 99-11 Dyna and 99-03 XL STATIC/DYNAMIC SEQUENTIAL SIGNAL MODULES •Allows for the three separate LED turn signals installed on the rear of the bike and flash sequentially •LEDs will also perform brake and running light functions •Includes color-coded replacement rear fender harness and installation instructions •Built-in load-equalizer prevents rapid flashing •Static sequential flashing: When the turn signal button is pressed, the first LED will light up followed by the second and third before all (3) shut off and the sequence starts again •Dynamic sequential flashing: When the turn signal button is pressed, the first LED will light up then power off, followed by the second on/off and third on/off before the sequence starts again •Dimensions: 2 7/8” L x 1 3/8” W x 7/8” D •Made in the U.S.A. NOTE: Be sure to identify which connector is on the bike before purchasing, as the factory was not consistent during 1994-2000. 2050-0215 0904-0002 2050-0315 2050-0303
RkJQdWJsaXNoZXIy OTcxOTk3